Retrofit Steering Column ididit（改造转向柱ididit）.pdfVIP

Retrofit Steering Column INSTALLATION INSTRUCTIONS for Chevy Tri-Five FOR PART NUMBER’S: 1120550010, 1120550020, 1120550051, 1070550030, 1070550040, 1120570010, 1120570020, 1120570010, 1070570030, 1070570040, 1140550010, 1140550020, 1140550051, 1150550030, 1150550040, 1160550010, 1160550020, 1160550051, 1140570010, 1140570020, 1140570051, 1150570030, 1150570040, 1160570010, 1160570020, 1160570051 S I N C E 1 9 8 6 610 S. Maumee St., Tecumseh, MI 49286 PH: (517) 424-0577 FAX: (517) 424-7293 Instruction # 8000000000 REV 08/15 Thank you for purchasing the Tri-Five Chevy column from ididit. This is a simple overview of how to mount your column. Any steering column must be secured at the dash and firewall. This column will use all the original mounting brackets at the dash. If you are missing parts, some are available from Ecklers, or Danchuck. Both have web sites to visit if necessary. In these instructions we assume either the original gear box or an aftermarket box are mounted in the original position. Since the gear box is so close to the firewall, only a coupler (manual) or rag joint (power) are necessary. If you have done a frame off restoration, the distance may have changed between the body and the frame. Remember, the steering column is one of the few parts that relate to both body and chassis. If the body is placed slightly back from the original position, you may need to add an inch to the column. We will be happy to exchange this column (in original condition). We cannot be responsible for body placement. If you have added a rack and pinion front end, the installation will require 2 joints and a shaft to reach the rack. This would be more of a “hot rod” installatio