MSC.MARC2005之超塑成形(SPF)实例.pdfVIP

Chapter 3.16: Super Plastic Forming (SPF) CHAPTER Super Plastic Forming 3.16 (SPF) ■ Chapter Overview ■ SPF Modeling ■ SPF with Adaptive Remeshing 3.16-2 Chapter Overview MSC.Marc User’s Guide Chapter 3.16: Super Plastic Forming (SPF) Chapter Overview A flat sheet is formed into a rigid die by pressure. The die is three-dimensional and represents a corner of a pan. This fine-grained material is assumed to be a rigid-plastic material with no elasticity and the flow stress is only a function of the strain rate. As the sheet contacts the die, friction causes the thickness of the sheet to vary. In addition the pressure must be adjusted to keep this strain rate sensitive material within a certain target range. This is necessary to maintain the proper flow of the super plastic material. Prediction of thinning of the sheet is very important since the sheet may become too thin for its application. Figure 3.16-1 Sheet Before and After Forming The SPF Pressure control in Load Case is used to automatically adjust the pressure on the sheet to keep within the target strain rate. Furthermore, the maximum pressure is limited by the capacity of the rig used to form the sheet. Units used are inches, pounds, and seconds. MSC.Marc User’s Guide SPF Modeling 3.16-3 Chapter 3.16: Super Plastic Forming (SPF) SPF Modeling This problem will d