JSC-SE气垫式避震器安装说明JSC-SEairmountsinstallationguide.PDF

JSC-SE 氣墊式避震器安裝說明 JSC-SE air mounts installation guide 安裝前，請確認避震器之型號規格是否正確。 Before installation, make sure the model and the specification are correct. 安裝說明 Installation guide • 將避震器放置在預定位置上後，將設備鎖固在上鐵板機器固定孔處；再將避震器固定在安裝位置處，注意 鎖固時請先套入華司墊片，且高度調整閥頂桿需接觸到安全高度調整螺栓。(參固定孔位圖) Lock the equipment on the fixed holes of upper iron plate after placing the mounts on the planned location. Afterwards, fasten the mounts on the installation location with washers and make sure the rod reaches the height adjustment bolt. (fixed hole diagram) • 將L型固定片移除。 RRemove LL-shhapedd bbrackketts. • 安裝完成後，配接氣壓管路(參配管示意圖)。 Install pressure piping after the installation (piping diagram). C • 在充氣時，可參考內壓VS荷重資料(圖一)，利用壓力調整閥將充氣內壓調整比目前荷重值對應的內壓大，等避 震器上鐵板上升時，再依荷重調整回適當內壓。 Please refer to (Fig 1) for the inner pressure vs loading information during the inflation. Apply a bigger inner pressure through the pressure gauge during the inflation. Adjust the inner pressure according to thethe loadingloading afterafter thethe upperupper ironiron plateplate arises.arises. S 型號 Type 200-SE 400-SE 700-SE 1200-SE 2000-SE A 140 160 200 250 350 B 115 125 160 200 300 C 160 190 220 270 380 J 尺寸 D 135 150 180 230 340 Dimension E 202 237 267 318 425 (mm) H 147 147 147 147 147