nxt教学搭建车型.pdfVIP

9797 NXT LEGO Kit: Basic Car Building Instructions © 2008 LEGO Tufts University Center for Engineering Educational Outreach NXT Basic Car Building Instructions Table of Contents: A. 2-Motor Car Page 3 B. 2-Motor Car Equipped With a Light Sensor Page 10 C. 2-Motor Car Equipped With a Touch Sensor Page 12 D. 2-Motor Car Equipped With a Skid ‘Wheel’ Page 14 E. 2-Motor Car Equipped With a Swivel Wheel Page 17 © 2008 LEGO Tufts University Center for Engineering Educational Outreach 2 NXT Basic Car Building Instructions A. 2-Motor Car Required Pieces: © 2008 LEGO Tufts University Center for Engineering Educational Outreach 3 NXT Basic Car Building Instructions Step A.1: NXT Preparation Side Views Attach a double black connector peg and a single black connector peg to both sides of the NXT. Connect the double peg vertically in the top most holes. The single peg should be connected in the middle horizontal hole. Your NXT should look like the below picture before moving on to the next step. © 2008 LEGO Tufts University Center for Engineering Educational Outreach 4 NXT Basic Car Building Instructions Step A.2: Attach Motors to the NXT Side View Top View Attach the motors (one per side) to the NXT using the double black connector pegs and the short black connector pegs attached to the NXT. The red dots in the side view identify which holes on the motor attach to the pegs. Your NXT should look like the below picture before moving on to the next step. Note: The top connection of the double black connector peg is not connected to anything. © 2008 LEGO Tufts University Center