BacktoBack PWM Converter Fed PMSG Wind （美联储PMSG风BacktoBack PWM变换器）.pdf

IOSR Journal of Engineering (IOSRJEN) e-ISSN: 2250-3021, p-ISSN: 2278-8719 Vol. 3, Issue 7 (July. 2013), ||V6 || PP 19-25 Back-to-Back PWM Converter Fed PMSG Wind Turbine System 1 2 3 4 K. Damodarareddy , P. Nagarajaram , Md. Asif , B. Ramu (EEE, Vardhaman College of Engineering (Autonomous), JNTU, Hyderabad, India) Abstract : - This paper presents a DC-link voltage controller using feedback linearization technique for the PMSG wind power system for the grid voltage sag. The DC-link voltage control is achieved by the generator side converter instead of the grid-side converter. Considering the nonlinear relationship between the generator speed (ωm) and DC-link voltage (vdc), a DC-link voltage controller using feedback linearization technique is verified with PI and FUZZY controllers. The grid-side converter controls the grid power for MPPT. The validity of this control algorithm has been verified by simulation results for 2MW PMSG wind power system. Keywords: - Back-to-Back PWM converter, feedback linearization, MPPT, wind power system. I. INTRODUCTION Wind power generation is the most rapidly growing energy source. Direct-drive wind energy conversion systems based on PMSG (Permanent-Magnet Synchronous Generator) have some advantages such as no gearbox, high power density, high precision, and simple control method [1], [2]. In order to achieve objectives such as continuity and security, high levels of wind power are confronted with new challenges as well as other new approaches in the power system operation. Therefore some countries have issued dedicated grid codes for connecting the wind power systems to the grid [3]. Lately, the micro-