Beading Tool Veritas Tools（卷边工具真理的工具）.pdf

Beading Tool 05P04.50 U.S. Des. Pat. D591,580 Introduction ® The Veritas Beading Tool allows you to quickly and easily add fi ne details to furniture by hand, without the substantial set-up and jigging that a router would require. The beading tool produces crisp beads, fl utes, and reeds — even in diffi cult hardwoods. Its symmetrical design can be confi gured for both personal comfort and as required to deal with reversing grain. The beading tool includes a 3/32 radius single-point cutter and fi ve blank cutters for custom shaping. (Other cutters are listed on page 8.) Knob Cutter Fence Body Square Socket Handle Clamp Bar Figure 1: Beading tool parts. Configuring the Beading Tool Before any beading can begin, the tool must fi rst be set up for the work at hand. Examine your workpiece to determine whether the tool should be confi gured for left-handed or right-handed operation. Left-Handed Right-Handed Configuration Configuration Figure 2: Set-up based on application. To reconfi gure the tool, use a slot screwdriver to remove the screws that fi x the clamp bar to the body. Remove the clamp bar and place onto the opposing side, aligning the bosses with their corresponding holes. Reinstall the screws. 2 Figure 3: Reconfiguring the tool. Positioning the Fence The fence on the beading tool has three different reference surfaces, each of which is used for following different edge shapes. Table 1 Refe