CHAPTER 26 WELDING AND OTHER HOT WORK （26章焊接和其他热工作）.pdf

CHAPTER 26 WELDING AND OTHER HOT WORK SECTION 2601 RESPONSIBLE PERSON. A person trained in the safety and GENERAL fire safety considerations concerned with hot work. Responsi- ble for reviewing the sites prior to issuing approvals as part of 2601.1 Scope. Welding, cutting, open torches and other hot the hot work program and following up as the job progresses. work operations and equipment shall comply with this chapter. TORCH-APPLIED ROOF SYSTEM. Bituminous roofing 2601.2. Deleted. systems using membranes that are adhered by heating with a 2601.3 Restricted areas. Hot work shall only be conducted in torch and melting asphalt back coating instead of mopping hot areas designed or authorized for that purpose by the personnel asphalt for adhesion. responsible for a Hot Work Program. Hot work shall not be conducted in the following areas unless approval has been obtained from the fire code official: SECTION 2603 1. Areas where the sprinkler system is impaired. GENERAL REQUIREMENTS 2. Areas where there exists the potential of an explosive 2603.1 General. Hot work conditions and operations shall atmosphere, such as locations where flammable gases, comply with this chapter and NFPA 51B. liquids or vapors are present. 2603.2 Temporary and fixed hot work areas. Temporary and 3. Areas with readily ig