Corrosion and Protective Coating Technology（腐蚀和防护涂层技术）.pdfVIP

INDUSTRIAL PAINTS 6. Priming Surface coating specialists think in terms of coating systems, Zinc phosphate is a non-toxic environmentally non- rather than individual products, with prime coats, build coats polluting inhibitive pigment that is now experiencing and finish coats performing their separate functions in carefully widespread use because of its proven effectiveness planned combinations. in urethane oil and chlorinated rubber based coatings. It is also widely used in epoxy based Prime coats are used: primers because, being virtually insoluble in water, it (a) To prevent or retard the spread of corrosion from does not contribute to osmotic blisters. pinholes in the coating film or breaks in the coating system caused by mechanical damage. (b) Non-lnhibitive Primers are based on non-reactive, (b) To provide good adhesion to the surface for water-insoluble pigments such as talc, silica, mica, subsequent coats which may not have good aluminum flake, and micaceous iron oxide. They are adhesive properties. Protect a blast cleaned surface most often used on non-ferrous and concrete