ADSLoadPull课件.pptVIP

Andy HowardApplications Engineer28 May, 2002;Outline ;Load pull simulation varies the load reflection coefficient presented to a device...;…to find the optimal value to maximize power or PAE, etc.;Specify the load reflection coefficients;Sweeping rho over a circular region ;Use ReflectionCoefUtility data display to help set s11_center and s11_rho;Two variables are swept to generate the points within the desired circle;More on the swept variables;Sweep limits for “imag_indexs11”;What is “max_rho”?;What about the “max_rho/(lines+1)” term?; maximum value of c_limit ;How is c_limit calculated?;How are the number of lines and the points per line calculated?;Alternate reflection coefficient sweep;Outline ;You could make the load independent of frequency:;Set source and load impedances at harmonic frequencies arbitrarily;Defining a single, frequency-dependent reflection coefficient (1);Defining a single, frequency-dependent reflection coefficient (2);Defining a single, frequency-dependent reflection coefficient (2 continued);How is iload calculated?;More details;Load pull at a harmonic frequency;Outline ;Modify the bias network as desired;Outline ;Calculate the DC power consumption;Calculate the power delivered and PAE;Pdel_Watts and PAE are functions of the twoswept variables;Outline ;Most simple contour lines;May specify specific contour values;More complex but more flexible contour equations;Generating contour lines for rectangular plots;Generating contour lines for Smith chart;Generating contours after sweeping magnitude and phase of rho;Plotting the actually-simulated reflection coefficients;PAE and power delivered are functions ofthe swept variables;Summary