宜家供暖(宜昌)-壁挂炉原理及故障排除（Ikea heating (yichang) - wall hanging furnace principle and troubleshooting）.docVIP

宜家供暖(宜昌)-壁挂炉原理及故障排除（Ikea heating (yichang) - wall hanging furnace principle and troubleshooting） The basic principle and working process of wall hanging furnace 1. Working principle When cb start later, after the system pressure is normal, the pump start promoting flow of heating medium water, open water flow switch or water flow sensor, the output current signal (or pulse signal switch signal) to the host controller, the host controller after receiving signal flow, start the fan before cleaning, and the detection of various safety device is normal, normal operation of the various safety devices, ignition, and open on, the secondary valve respectively, gas into the burner under the action of electric spark to ignite gas for combustion (in the process of ignition, the fan is usually half speed operation or run by inertia, power after burning point, according to the quantity of gas determine the fan speed. For using gas proportional valve type, proportional valve ignition current and minimum current, the maximum current, and can be adjusted respectively), by ion flame technology makes the normal combustion flame, heating medium through the radiator sends out into the air or radiation, to achieve the purpose of heating. After reaching the set heating temperature, quenching the fire into standby mode. And so on and so on. 2. Working process Heating system to testing system pressure is normal, normal work water pump, water flow switch or open flow sensor to output flow signals - into the fan before cleaning, test of wind pressure is normal, the safety devices and normal ignition (fan power or enter into a low speed on inertia operation) and electromagnetic valve to open the first and second level respectively (proportional valve is automatically entered into the ignition gas quantity, block valve into the small fire ignition) - point on fire - ion flame, the feeling of normal combustion, fan into the normal speed to reach the set temperature, die - fan to enter after cl