氧传感器的检查绝招（Check the oxygen sensor）.docVIP

氧传感器的检查绝招（Check the oxygen sensor） Check the oxygen sensor Questioner: the eye of the leaf is 2012-1-12 Satisfied with the answer The oxygen sensor is installed in the exhaust pipe of the engine and is used to measure the oxygen content in the exhaust gas before the three-effect catalytic converter. If the oxygen content in the exhaust gas is high, the mixture is weak, the oxygen sensor will input this information into the engine electric control unit (ECU), and the ECU instruction injector will increase the injection amount. If the oxygen content in the exhaust gas is low, the mixture is concentrated, and the ECU instruction injector reduces the fuel injection volume, thus helping the ECU to control the air combustion ratio of the mixture to the theoretical value (14.7). Therefore, the oxygen sensor is equivalent to the concentration switch of a mixture. It is an important part of the closed-loop control of the electric jet engine. The oxygen sensor is a heat sensitive voltage sensor Oxygen sensor indirectly reflect into the concentration of the mixture in the cylinder, this kind of information is the fluctuation of voltage is passed to the electronic control unit (ECU), thus determine oxygen sensor performance is the main method of testing the oxygen sensor output signal voltage and its volatility and the range of frequencies. On the other hand, the engine only has to reach a certain temperature to activate the oxygen sensor. Testing before the oxygen sensor, therefore, must be on engine preheating fully, the oxygen sensor to normal working temperature 300 ℃ ~ 350 ℃ before testing, before this, the resistance of the oxygen sensor, like open, oxygen sensor does not produce any voltage signal; If the engine exhaust temperature over 800 ℃, the control of the oxygen sensor will interrupt. The existing models using principal, vice 2 oxygen sensor, the main oxygen sensor (before) usually with heater, deputy oxygen sensor with heater, want to rely on waste gas preheating