水利工程协会质量检测员继续教育 金属结构检测试卷（The quality inspector of the water conservancy engineering association went on to test the education metal structure）.docVIP

水利工程协会质量检测员继续教育 金属结构检测试卷（The quality inspector of the water conservancy engineering association went on to test the education metal structure） The total score: 100 points Exam time: 100 minutes Remaining time: 98 minutes 41 seconds Metal structure engineering exam paper (1 point, 40 points) (1) after the mobile hoist bridge frame and the assembly of the door frame are completed, the test span is (). 1 (0.9 ~ 1.4) L / 1000 (1.0 ~ 1.4) L / 1000 (1.1 ~ 1.4) L / 1000 (2) the limit deviation of the grid spacing of the grille is the design spacing (). 2 Plus or minus 3% Plus or minus 5% Plus or minus 8% Plus or minus 10% (3) the location tolerance of the mushroom head center of the human word gate should not be greater than () mm. 3 1 1.5 2 2.5 (4) after the installation of the human word gate is completed, the gate () shall be adjusted to the gate under free suspension The door shaft and the diagonal pillar Top pivot rod Back pull rod At the end of beam (5) the load test, the scraper type rack cleaner should be according to the actual type and proportion of catching, taking scraper () times the volume of waste placed in scraper scraping location, do the scraper scraping dirt and unloading movement three times. 3 2 3 4 5 (6) the combined error of load limiter of rotary cleaning machine should not be greater than () 2 2% 5% 8% (7) hoist connect electrical test before should check all wiring and conform to the requirement of drawing, line of insulation resistance should be greater than M Ω (). 2 0.1 0.5 1.0 1.5 (8) surface pretreatment and coating construction, the surface temperature of the substrate metal shall not be lower than the atmospheric dew point (). 2 - 3 ℃ 3 ℃ 5 ℃ 10 ℃ (9) fixed winding type hoist coupling area of no more than a single shaft hole surface defects was (), depth of no more than the () % of the nominal wall thickness at that point, the number of defects no more than 2, and the spacing between two defects is not less than 50 mm, can be considered qua