离合器分离轴承发生故障的原因（The cause of the failure of the clutch release bearing）.doc

离合器分离轴承发生故障的原因（The cause of the failure of the clutch release bearing） Clutch release bearing is one of the most important parts in the automobile. If the maintenance is not good, it will cause the economic losses, and it will be very troublesome to assemble and disassemble, and it will take a lot of time. So, to ascertain the cause of clutch bearing failure, and reasonable maintenance and maintenance in use, to extend the separation bearing life, improve labor productivity, has important significance to achieve better economic benefit. The function and requirements of clutch bearings, clutch release bearing is mounted between the clutch and transmission, separation in the tubular transmission bearing sleeve bearing cap of the primary shaft extension, through a return spring to shoulder separation bearing has always withstood the separation fork, and returned to the last position, maintain a gap of about 2.5mm and separation lever. Since the clutch plate, the release lever and the engine crankshaft synchronous operation, and the separation fork only along the axial movement of the output shaft of the clutch release fork, directly used to dial the release lever is clearly not enough, can be separated by separating the bearing lever rotates along the clutch output shaft axial movement, so as to ensure the smooth, soft, clutch separation reduces wear the clutch and transmission, prolong the service life of. Clutch separation bearings should be flexible, without sharp noise or clamping phenomenon, the axial clearance shall not exceed 0.60mm, the inner ring wear shall not exceed 0.30mm. Two, separation bearing damage fault judgment and reason (a) fault judgment, if the clutch separation bearing can not meet the requirements, as a fault. After a fault occurs, first of all to determine which phenomenon belongs to the separation of bearing damage. After the engine starts, lightly clutch pedal, when the free stroke just eliminates, rustle the sound is for the separation bear