vesda基本知识（VESDA basic knowledge）.docVIP

vesda基本知识（VESDA basic knowledge） VESDA basic knowledge 1 what is the maximum protection area of a single VESDA detector? Standard and scanning type 2 detectors, maximum protection area of 2000 square meters, economical detector maximum protection area of 500 square meters. But in high-risk places, the detection range will be reduced, it is suggested that the maximum protection area should be 500----1000 square meters. 2 、 sampling mode of VESDA system Standard sampling: under the ceiling, under the ceiling and under the floor Capillary sampling: concealed, ceiling and cabinet Return air sampling: inner and return air grille 3 、 what is the maximum length of the sample tube? The total length of the four sampling tubes on a VESDA detector shall not exceed 200 meters, and the length of each tube shall not exceed 100 meters. However, it is permissible to exceed the time at which the end of the sampling tube reaches the detector for no more than 120 seconds. But the total length is still not more than 200 meters. 4. How about the distance between sampling points in a protected area? No matter what sampling method is adopted, the maximum distance between sampling points shall not exceed 9 meters, and the minimum shall not be less than 1 meters. 5, in the sampling tube design, laying, should pay attention to what problems? (1) the sampling tube adopts PVC pipe, and the diameter of the pipe should be between 19 and 25 millimeters. (2) the PVC glue seal is applied at the pipe interface, but the joint of the sampling tube and the detector shall not be sealed. (3) the pipeline should be fixed every 1.5 meters (4) curved elbows should be used at corners, and right angles bend is not allowed. (5) the sampling network of the same detector can not monitor different types of environment, because it will seriously reduce the reliability and effectiveness of the whole system. 6, how to eliminate the emergency air flow fault? When the sampling tube in air continuously above or below t