常见故障处理1（Troubleshooting 1）.docVIP

常见故障处理1（Troubleshooting 1） Mahjong machine in use will always encounter such and such problems, especially the old products, you say it has ten thousand problems, that you are too belittle it. The following is suitable for most mahjong machines, for reference purposes only: First, the switch indicator light is not bright, the machine did not respond. 1. Check the power supply; 2, check the power plug two head plug in, the power supply socket is loose; 3, fuse whether fuse or bad contact?; 4. Check all the plug on the reverse of the switch is loose; 5 、 the power switch may be damaged; Two, the operating panel above the indicator light, press the lift key, the operating disk does not move: 1. First try to remove all the cards from the track; 2 、 under the operation panel, the plug is loose and the contact is bad; 3, check the operating panel and the main plug is loose; 4, check the 07 parts of lifting motor and screw, light control, switch. Three. When the machine is working, press the lift button and the operating panel does not move: 1, try to track all the cards out; 2 、 the lift button is dirty or damaged. Four, the machine normal work, need to fill the card: Press two lifting buttons at the same time before you finish. Five 、 the tray is not up and down: 1 、 the mechanical part of the lifting component is friction; 2 、 the operation board lifting button is too dirty; 3, 07 light control installation distance is not in place or loose or damaged; The six and 01 parts are free from pushing: 1, the 01 part of the photoelectric sensor S1 ground, damaged, dirty or blocked by foreign bodies; 2, sensitivity is too low, adjust the S1 part of the variable resistance, so that it is normal; 3. Check the location of the track and push device; 4, the card is dirty; 5. Check all mechanical and electrical components related to the 01 part, whether all the plugs are loose or broken; 6. Check whether the motor or capacitor is damaged. Seven, the 01 part has the card phenomenon: T