飞针测和ict区别（Flying probe and ICT）.docVIP

飞针测和ict区别（Flying probe and ICT） Flying needle test is the latest solution to some major problems in electrical testing. The provenance of the name is based on device functionality, indicating flexibility. It is used to replace the probe needle, using more than one driven by the motor, capable of rapidly moving electrical probe device with pin contact and electrical measurement. The instrument was originally designed for bare boards and also requires complex software and procedures to support, and has now been able to effectively simulate online testing. The emergence of the flying needle test has changed the testing methods for low yield and fast conversion (quick-turn) assembly products. Tests that took weeks to develop are now several hours away. In the severe time to market (time-to-market) electronic manufacturing services under pressure (EMS, Electronic Manufacturing Services) provider, greatly the back-end compensation capacity front-end technology and process time saving, such as continuous flow manufacturing and logistics of the just in time (just-in-time). Greatly shorten the product design cycle and market time. The disadvantage of rapid conversion is that PCB can be assembled rapidly in a variety of environments, depending on the interconnect technology and the density of the board. Customers are often willing to pay a little extra for this kind of performance. However, when the PCB has been assembled but cannot be tested within an acceptable time frame, they are reluctant to pay the delayed price. Unacceptable testing time frame delays final shipment for two reasons. One reason is the lack of flexible hardware; the second is the test development time spent on a given product. Many of the original equipment manufacturers (OEM) are reluctant to accept the cost of fast conversion (fast-turn) assembly when they do traditional, fast, and no price penalty boards. EMS with fast conversion services, but not shipped within the time frame of OEM, be sure to look f