高级汽车修理工试卷6（Senior mechanic test 6）.docVIP

高级汽车修理工试卷6（Senior mechanic test 6） First, multiple-choice questions (first ~ 60 questions). Choose the correct answer and put the corresponding letters into the brackets in the questions. 1 points for each question. 60 points!): 1. in the theory of mixing heating, the heat efficiency is higher if the compression ratio is equal to the total heating quantity, and if the pressure rise ratio is increased (). (A) constant (B) becomes high (C), decreases (D), becomes high first, then becomes low 2. the purpose of closing the intake valve is (). (A) reducing the flow resistance (B) of the intake air, and increasing the valve lift of the intake valve (C) make full use of the flow inertia of intake air flow (D) to improve the economy of the engine 3. in order to improve the coefficient of inflation, the resistance of the intake system should be reduced, while the intake passage of the whole intake system is the smallest and varies continuously, and the maximum flow resistance should be considered first. (A) carburetor (B) intake valve (C) intake manifold (D) air filter; 4. which of the following concentrations makes the combustion more complete and the fuel consumption rate lowest (?). (A) alpha = 0.85 to 0.95 (B) alpha =1 (C) alpha =1.05 to 1.15 (D) alpha 0.85 to 0.95; 5. in the combustion process of a diesel engine, the crankshaft angle is generated from the first flame center to the rapid combustion of the mixture in the cylinder. When the pressure in the cylinder reaches the highest point, it is called (). (A) late ignition (B), quick burning (C), slow fire (D), and afterburning 6., in order to reduce the roughness of combustion, the direct injection diesel engine selects the fuel injection law, requires fuel injection (). (A) maintain a high injection rate (B) and maintain a low injection rate (C) first urgent, then slow (D), first slow, then urgent 7. gasoline engine torque reserve coefficient (diesel) torque reserve factor, so it does not need to change the use of low