焊缝要求（Weld）.docVIP

焊缝要求（Weld） Two welding requirements of 2010-08-20 15:40:21| classification: welding material | Tags: | font in Small subscription Two welding requirements A butt weld in grade one and grade two, weld the main difference is what? GB 50205-2001 steel structure construction quality acceptance table 5.2.4 have clearly stated, a level detection ratio of 100%, while the two level inspection proportion requirement is 20%. In the project of butt weld of the more commonly used for level two, but the component, fatigue calculation in need of heavy duty and the weight of more than 50 tons of specific parts is equal to the intermediate duty crane beam component is required by a butt weld. In the standard steel structure design should have a detailed provisions. (GB 3323-87) according to the relevant provisions of weld quality: 16.1 according to the nature and number of defects, the weld quality is divided into four levels. The internal 16.1.1 grade I weld without crack, lack of fusion, lack of penetration and stripe slag. The internal 16.1.2 II weld without crack, incomplete fusion and penetration. Internal 16.1.3 grade weld without crack, lack of fusion and double welding and welding pad added in unweld. One side welding without backing the nonpenetration allowed according to the length of grade evaluation table 10 stripe slag length. 16.1.4 weld defects than level III for class IV. Welding inspection 1. qualification In the steel structure of NDT personnel must meet with issued by relevant government departments and their work qualifications, to detect the need to detect the parts according to the specification. 2. in addition to routine check, the steel structure sampling check points, factory production and installation of weld seam of two kinds of checks. 3. visual inspection A. all welds should be cooled to ambient temperature after visual inspection, weld class II and III steel to be welded is completed after 24 h examination results as the basis for acceptance. There sh