电子围栏维修（Electronic fence maintenance）.docVIP

电子围栏维修（Electronic fence maintenance） ALEPH infrared radiation probe debugging guide Before you debug the ALEPH infrared probe, we hope to do the following preparations. 1. make sure all probes are properly wired and wired; 2. the installation of the probe conforms to the requirements of the instruction manual; 3. read the product manual carefully before installation; 4. fully understand the basic working principle of infrared probe; 5. after the power supply, please first measure the transmitter and receiver power supply terminal voltage, the voltage must be specified in the manual voltage range; 6. read the instructions for the adjustment of the optical axis. After doing the above preparation, you can smoothly adjust the ALEPH infrared counter probe according to the following procedures. Of course, the following debugging requires more than 2 personnel, in order to facilitate the description, we set A, B two people, and equipped with walkie talkie. HA-20/40W The receiver ALEPH probe has a series of red paper filter, the filter when debugging, must cover the infrared receiver at the receiving end, the infrared light intensity received attenuation, to simulate a bad weather condition. After debugging, take it down so that the probe is in the best working condition. Debugging steps: The first visual transmitter and receiver are located on the same level; otherwise adjusted (by transmitter and receiver sight). Using a suspension hammer, test the transmitter and receiver at the same time whether the vertical adjustment; otherwise. Open the shell of the transmitter and receiver to confirm whether the red filter is covered on the receivers optical module. Setting the multimeter in the DC 10 or 20V gear and inserting the measuring rod into the receiver test hole (note + polarity). A people observe multimeter readings, B person to launch adjustment. First adjust the direction about B people, pay attention to start slowly from one direction, A observation readings, reaches t