缝纫机解决办法（Sewing machine solutions）.docVIP

缝纫机解决办法（Sewing machine solutions） This paper mainly introduces the causes and maintenance methods of common troubles in household sewing machines from the aspects of feeding, running and stitch. Failure in feed 1. seam wrinkle analysis: machine needle broken point, the bottom line tension is too large, differential adjustment is improper. Methods: to replace the new machine needle, unscrew the bobbin spring screw, re adjust the differential mechanism. 2. seam material is broken below to bite to form grid mark; analysis: send cloth tooth tip too sharp, presser foot pressure is too big. Processing method: grinding whetstone available feed tooth tip, loosen the pressure foot pressure adjusting screw. 3. seam material under the cable hair, sewing when there is interruption of fiber sound; analysis: machine needle broken tip or too blunt. How to handle: replace the new machine needle. 4. stitching stagnation; analysis: too low delivery teeth, presser foot pressure is too large. Handling method: lifting cloth screw and tightening screw. 5. stitching back and forth; analysis: send cloth teeth too high. Treatment method: adjust feed teeth. Malfunction in operation 1. head rotating stagnational; analysis: wrong lubricating oil, especially with vegetable oil; shuttle bed too much dirt; the connecting rod screw and conical screw is too tight. Treatment method: after flushing with kerosene, refill the sewing machine oil again; clean the shuttle bed; adjust the loose screw to ensure the clearance. 2. transfer, half circle, half circle or slow light slip each turn there is a stagnation point; analysis: Shuttle round thread operation not only half circle stagnational and accompanied by severe jitter and noise; cloth feeding teeth position high or teeth accumulate dirt, make the cloth feeding teeth collide with the needle plate rises. How to do it: clean the shuttle bed and add a little oil to the shuttle Traces of faults 1. lines are floating; analysis: pinch device pressure is to