螺纹车削不稳定及改进方法（Instability of thread turning and improvement method）.doc

螺纹车削不稳定及改进方法（Instability of thread turning and improvement method） The thread turning instability and improving method The threat of instability At present, in the CNC lathe thread turning is very common. With other indexable turning tool, thread cutter performance has been continuously improved. Compared with most other turning process, thread turning factors should be considered when some more. However, this does not mean that the thread turning is more difficult than other processing. The correct choice of CNC tool and application skills to ensure the accurate and efficient machining with threads. In fact, due to the threaded screw processing can not always be in the ideal state. With the use of thread angle, fillet radius is basically the same as the forming of thread machining cutting edge, this implies the need for a sharp cutting edge and easily damaged. In addition, whether processing fine thread or coarse thread need use very large feed. Many threads with strict quality requirements, requirements of precision and high consistency processing. Some are in thread machining difficult to machine materials. In conclusion, compared with other ordinary processing, processing of thread processing is not ideal for reliable, efficient and long tool life. However, carefully consider some factors, people can now easily thread turning well run, can the thread turning process optimization, to reach the level of higher production efficiency. The key point to note is that the final result of thread turning and machining cost depends directly on the machine tool, workpiece, configuration, and handle between indexable inserts and processing method, programming and cutting parameters, the instability refers to cutting edge instability, is considered the biggest threat to the ideal processing results. The potential improvement of thread turning In thread cutting, and the processing results lead to performance problems is not ideal for metal cutting is usually due to common basi