叉车理论试卷 3（Forklift theoretical papers 3）.docVIP

叉车理论试卷 3（Forklift theoretical papers 3） Judgment question 1: diesel fuel ejected from the injector must be in line. (wrong) 2: in accordance with the special equipment safety supervision Ordinance stipulates that the use of special equipment units for more likely accidents and accidents, it is necessary to develop contingency plans for emergency. (wrong) 3: crankcase must be ventilated. (to) 4: thermostat changes the cooling water circulation path. (to) 5: same label gasoline, motor vehicles to plateau, ignition advance angle should be increased. (to) A 6: engine is a machine that transforms the heat of fuel combustion into mechanical energy. (to) 7: loader with fork steering bridge. (wrong) 8: simple, unbalanced wheel brakes with unequal braking forces between the front and rear brake shoes. (to) 9: DC motor can realize voltage regulation and speed regulation. (wrong) The pulley lifting device 10: part of the free forklift installed on both sides of the door frame. (wrong) 11: important parts can be taken by fork trucks inertial force. (wrong) 12: cargo beyond the ships side can be removed directly on the shore. (wrong) 13: finished, put the loaders bucket flat on the ground. (to) The signs of deterioration of 14: brake equipment are braking distance extension, braking deviation and braking sideslip. (to) The accelerator pedal of the 15: diesel engine controls the throttle opening of the carburetor and controls the amount of combustible mixture entering the cylinder. (wrong) When the 16: charging system is working normally, the ammeter pointer should point to +. (to) The crankshaft of the 17: four stroke engine rotates for two weeks, and the camshaft of the valve mechanism rotates for two weeks. (wrong) The 18: exhaust valve opens at 40 degrees to 70 degrees before the piston reaches the lower dead center. (to) 19: forklift work device hydraulic distributor valve stem and valve gap is too large fork lift fork too fast or too slow. (to) 20: fuel injector is not allo