0r电阻的功能（The function of 0r resistor）.docVIP

0r电阻的功能（The function of 0r resistor） 0 Ohms resistance may have the following functions: Use as jumper. The utility model has the advantages of beautiful appearance and convenient installation. In digital and analog hybrid circuits, two separate and single point connections are often required. We can connect these two places with a 0 ohm resistor, not directly together. The advantage of this is that the ground wire is divided into two networks and will be much more convenient when handling copper in a large area. By the way, such occasions are sometimes inductance or Magnetic beads to connect. Work as a fuse. Because the fuse current on the line of PCB is larger, it will be difficult to fuse if there is a fault such as short circuit, over-current and so on, which may lead to greater accidents. Since the resistance of the 0 ohm current is relatively weak (in fact, the 0 ohm resistance is also a certain resistance, but only very small), the current will first fuse the 0 ohm resistance, thus disconnecting the circuit, Prevention of greater accidents. Sometimes a small resistance with zero resistance or a few ohm is used as a fuse. However, this is not recommended, but some manufacturers in order to save costs, Thats all for it. Position reserved for debugging. You can decide whether to install, or any other value, as needed. Sometimes it is marked by *, indicated by debug decisions. Use as configuration circuit. This function is similar to the jumper or dial switch, but is fixed by welding, thus avoiding the modification of the configuration by the ordinary user at will. By installing resistors at different locations, you can change the function of the circuit or set the address. 0 Ohms resistance specifications, usually divided by power, such as 1/8 watts, 1/4 watts, and so on. Basic knowledge of electronic components Identification of common components I. resistance Resistors are represented in the circuit by R plus numbers, such as: R15 means resistance with a numbe