2010高教社杯全国大学生数学建模(含abcd)（2010 High Education Club Cup National Undergraduate Mathematical Modeling (including ABCD)）.docVIP

2010高教社杯全国大学生数学建模(含abcd)（2010 High Education Club Cup National Undergraduate Mathematical Modeling (including ABCD)） \ Variable position identification and tank volume meter calibration of A storage tank Usually the gas station has a plurality of underground storage tanks and fuel storage, are generally matched with the oil level measurement and management system, the flow meter and the oil level gauge to measure the inlet and outlet oil volume and oil level height data, through the calibration of the tank capacity table (i.e. level height and oil storage tank the corresponding relationship between) calculated in real time, to get the changes of oil level and oil storage tank. After the use of a lot of oil tanks for a period of time, due to deformation of the ground and other reasons, the position of the tank will be inclined and horizontal deflection (hereinafter referred to as deflection), resulting in a change in the tank gauge. In accordance with the relevant provisions of the need for regular re calibration of tank volume table. Figure 1 is a schematic diagram of the storage tank size and shape of a typical, the main body is a cylinder, both ends of the spherical crown body. Fig. 2 is a schematic diagram of the longitudinal tilting of the tank body; FIG. 3 is a cross-sectional view of the lateral deflection of the tank. Please use mathematical modeling method to solve the problem of tank location identification and tank volume table calibration. (1) in order to understand the effect of displacement tank on tank capacity table, using small oval oil tank as shown in Figure 4 (elliptic cylinder ends flat), respectively. No change in position and inclination angle of the tank? Vertical variable =4.10 two cases of the experimental, experimental data as shown in Annex 1. A mathematical model is established to study the influence of tank change on tank capacity table, and the tank volume meter calibration value of tank height 1cm after tank change is given. (2) for th