ansys_常见警告和错误（Ansys_ common errors and warnings）.docVIP

ansys_常见警告和错误（Ansys_ common errors and warnings） False possibility: 1) a rigid body displacement occurs, adding constraints 2) before solving merge or compression node 3) there is no contact, and if the definition of contact is incorrect, a similar situation will occur 4) this can happen if material properties are set incorrectly. For example, the density setting is too far off the mark; My own solution to this situation is to check the nodes without coupling; Ive encountered this situation and finally found that the density is off the mark; 2, Large, negative, pivot, value... May, be, because, of, a, bad, temperature-dependent, material, property, used,, in, the, model. The reason for this error is probably the lack of restraint! Please check the model carefully! I havent met the problem yet 3, after the beginning of the following tips, Solid, model, data, is, contaminated Finally, I found out why The finite element mesh contains lines that are not divided into grids. In general, there is a coincidence between the faces, which leads to the fact that the mesh is divided into lines, but contains lines that have not been meshed. The solution is to store the model in.Cdb format (remove geometry information) and then read it to solve it Command: cdwrite, DB, model name, CDB Sounds good, but I havent encountered it yet. After the partition, I use the NUMMRG command and merge elements to avoid this 4, * * * WARNING * * * There are 79, small, equation, solver, pivot, terms. Several possibilities: 1) the constraint is not enough, but the warning has 79 equations to appear small principal element, this one possibility is smaller, but may as well examine. 2) the material parameter has the question, may examine the material data whether to lose the mistake. 3) or some units did not make the material. You can use Select, Entities, -gt, Element, -gt, Attributes, -gt, Material, Type, -gt, and 0 (material number 0) to see if this is the case 4) the structure is not one, that is, t