2009年普通高等学校招生全国统一考试理综综合能力测试( …（In 2009, the unified national college entrance examination (the synthetical ability test...）.docVIP

2009年普通高等学校招生全国统一考试理综综合能力测试( …（In 2009, the unified national college entrance examination (the synthetical ability test...） The frictional resistance of slider movement f= (2) the length of the vernier caliper measurement of slider light readings as shown in Fig. Read d= 23. the slant angle cosine can be calculated directly; measuring principle is using photoelectric door average speed of a short time instead of instantaneous velocity; velocity by displacement relation can be considered when the acceleration of slider motion; friction can be obtained by quantitative kinetic friction. 23. scoring criteria: 10 points (1) (6 points) (2 points) II (2 points) (must bring -) (2 points) (without -) (2 points) (without -) (2) (2 points) d = 3.62cm (36.2mm is also OK) 24. (15) of the material resistivity changes with temperature for P = P 0 (1+ a T) One is called resistance temperature coefficient P 0 = 0 DEG C is resistivity at t; in a certain temperature range alpha is temperature independent constant The resistance of metals generally increases with increasing temperature Having a positive temperature coefficient; whereas certain nonmetals, such as carbon, are opposite Having negative temperature coefficients; complementary properties of two materials with positive and negative temperature coefficients It is possible to make resistance that does not vary with temperature within a given temperature range. It is known to be at 0 degrees C The resistivity of copper is 1.7 * 10-8 Omega M The resistivity of carbon is 3.5 * 10-5 Omega m; near 0 C. Copper resistance temperature coefficient is 3.9 * 10-3 C 1 The temperature coefficient of resistance to carbon - 5 x 10-4 DEG C to 1; the same cross-sectional area and element copper series 1.0m conductor The resistance is required to be near 0 DEG C without changing with temperature For the required element length (ignoring the carbon and copper bar size changes with temperature). 24. (15): set the standard for evaluation and analys