ansys使用技巧（ANSYS tips）.docVIP

ansys使用技巧（ANSYS tips） ANSYS usage skills 1. how to customize the user cross section of a Beam188189 unit ANSYS offers several common sections for users to choose from, but sometimes it does not meet the specific needs of users. To do this, ANSYS provides a way for the user to create a section (Library). If you need to create a non - Generic cross section, you must create a user grid file. Specifically, you first create a 2-D entity model and then use the SECWRITE command to save it (Main, MenuPreprocessorSections, -Beam-Write, Sec, Mesh). The details of the process are as follows: 1. create the geometry model of the section (two dimensional surface model). 2. set the number of units or the maximum size of the units for all lines (Main, MenuPreprocessor, -Meshing-Size, Cntrls-Lines-Picked, Lines, or MeshTool). Remember: the number of cell in the model must not exceed 250. 3. select the menu Main, MenuPreprocessorSections-Beam-Write, Sec, Mesh, pop up a pickup window, click Pick All to pick up all the faces of the containing space. 4. ANSYS automatically creates zone squares on all surfaces. When dividing the mesh, the message that ANSYS may display the shape of the cell is ignored or not displayed, but a message is always seen. Unable, to, mesh, area.... If you have completed the above work, you clear all the units on the surface (Main MenuPreprocessor-Meshing-Clear Areas) and repeat the second, third, fourth step, that is, you must re control the mesh density. 5. if the fourth step Write Section Library File pop-up dialog box, enter a File Name domain without using the SECT file name, Drives domain a section file designated storage drive, Directories domain a section file in the specified directory, and then click the OK button, complete user file creation section. If you specify too many units in the third step, the number of cells and nodes may exceed the limit, you must clear the 2~4 steps on all the faces until you get the appropriate number of squares and nodes