atc scm20的打摩（ATC scm20 rub）.docVIP

atc scm20的打摩（ATC scm20 rub） SCM20s rubbing: As mentioned above, there are many senior fancier was 20 (or 20T) to replace the high frequency unit of high quality, but I insisted on not only to replace the unit, the divider can also be a good tonic effect, it does not destroy his original style, but also can make the high frequency are improved to a certain extent. 1, first of all the inside of the lead out of the box, this is the most vulnerable part of the box, a few of the ordinary lead line quality is very general, looks very uncomfortable. The author uses diameter 2. Deputy special dragon 5 mm silver bag replacement. If the conditions to purchase the high-frequency unit lead the original two meters JENSEN pure silver wire will be better replaced.JENSEN pure silver about 100 yuan a metre. 2, the replacement of several capacitors high pass filter, has replaced conditions using the same numerical PPMFX MIT, the voice of the positive help is certain, especially high gloss gentle enhancement is 20 (T) required. However, the price of the capacitor is also very expensive, if not sure, you can also buy a few 0.22UF/200, and in the original capacitor, but also a certain improvement, nor will it affect the frequency response curve 3, the replacement of a few cement resistance high pass filter, high frequency of the box and the lack of extension points there is a direct relationship between the pressure resistance reduction rate, replacement without a sense of sheet resistance can be improved to a certain extent more high-quality Henkel HOLCO in the premise of not changing the original value of the. After doing the above link of tonic, you will feel SCM20 high frequency extension has obvious improvement, and not to the ATCs natural style has obvious interference damage. If you say the words, can put the inductor low pass filter for the SOLO with the numerical copper inductor, the sense of hearing will be faster, more and more low frequency strong, Fu Q elastic extension LMS