pcb设计经典技巧（PCB classic design skills）.docVIP

pcb设计经典技巧（PCB classic design skills） This paper consists of 544852010 contributions DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. PCB design experience skills, LED current up to dozens of mA, with the LED current lead length and path extension, LED ON/OFF often become peripheral power One The cause of noise (switching). Therefore, the drive transistor must be as close as possible to the LED in packaging so as to reduce the flow path of the LED current IC. The luminance of LED is proportional to the drive current. Generally, green LED is used as a benchmark. 2. How to avoid high frequency interference? The basic idea of avoiding high frequency interference is to minimize the interference of high frequency signal electromagnetic fields, which is called crosstalk (Crosstalk). The distance between the high speed signal and the analog signal can be pulled up, or the ground guard/shunt traces is added beside the analog signal. Also pay attention to the noise jamming to the analog ground digitally. 4, how is the differential distribution pattern implemented? There are two points in the routing of differential pairs. One is that the lengths of the two lines should be as long as possible, and the other is the spacing of the two lines (which are determined by differential impedances), which is to remain the same, that is, to keep parallel. There are two parallel ways, one for the two lines, the same on the line (side-by-side), one for the two lines, and two for the upper and lower levels (over-under). In general, side-by-side implemented more ways. 6. Can a matching resistor be added to the difference line between the receiver and the receiver? The matching resistance between the differential lines of the receiving end is usually added, and the value should be equal to the value of the differential impedance. The signal quality will be better. The routing of differential