powerpcb在印制电路板设计中的应用技术（The application of powerpcb technology in the design of printed circuit board）.doc

powerpcb在印制电路板设计中的应用技术（The application of powerpcb technology in the design of printed circuit board） Application of powerpcb in printed circuit board design Aileen 2004-12-8 9:57:09 Printed circuit board (PCB) is a support component of circuit components and devices in electronic products. It provides electrical connections between circuit components and devices. With the rapid development of electronic technology, the density of PCB is higher and higher. The quality of PCB design has a great influence on anti-interference ability. Practice has proved that even if the circuit diagram is properly designed and printed circuit board is not properly designed, it will also have an adverse impact on the reliability of electronic products. For example, if the two thin parallel lines of a printed board are very close together, a delay in the signal waveform is formed and a reflected noise is formed at the terminals of the transmission line. Therefore, in the design of printed circuit boards, we should pay attention to using the correct method, comply with the general principles of PCB design, and should meet the requirements of anti-interference design. I. General principles of PCB design To make the best performance of electronic circuits, the layout of components and wiring is very important. In order to design PCB with good quality and low cost, the following general principles should be followed: 1. layout First, consider the size of the PCB. When the size of the PCB is too large, the printed line is long, the impedance is increased, the noise resistance is reduced, and the cost is increased; when the utility model is too small, the radiating is not good, and the adjacent lines are easily interfered. After determining the size of the PCB, determine the location of the particular element. Finally, according to the functional unit of the circuit, all the components of the circuit are arranged. The following principles shall be observed when determining the location of a