低压配电基本安装规程（The basic installation of low voltage distribution）.doc

低压配电基本安装规程（The basic installation of low voltage distribution） Code for basic installation of low voltage distribution, basic installation code for 01:23 P.M. low voltage distribution on Wednesday, 05 October, 2008, 07 Author: administrator source: lighting technology network time: 2007-04-16 Keywords: installation of low-voltage distribution I. requirements of low voltage distribution room 1) the door shall be opened outwards, and the door shall be fitted with a guard against the mouse; 2) there are lighting windows and ventilation shutters, shutters should be rainproof, snow, small animals into the room; 3) there should be a slope and a sump at the bottom of the cable trench; 4) a cable trench without a tray shall be provided with a trench cover plate; 5) the front channel is larger than 1.3 meters, the rear passage is larger than 0.8 meters, and there is a safety barrier; 6) the floor elevation of a power distribution room shall be more than 0.5 meters. Two 、 distribution panel installation 1) the Distributor shall be a standard disk with a top and a front door; 2) the color of the Distributor shall be uniform, with no scratches on the surface; 3) the switchboard bus should be color coded; 4) the Distributor shall be installed vertically and the deviation of verticality is less than 5o; 5) when the door is closed or opened or closed, there should be no sloshing of the disc body; 6) the ammeter, voltmeter and so on are installed on the switchboard; 7) the outlet line of the Distributor shall be marked; 8) distribution of a bus as far as possible by a copper wire connection, crimping screws on both sides of a gasket, a spring washer nut side, such as the multi strand copper plastic connection shall be pressed copper nose; 9) two line control panel should focus on wiring, and use a plastic belt and bandage bandage, control cable, spare wires wound in control cable branch spiral; 10) the transformer, the motor protector and other small parts of the switchboard should