锚杆施工方案（Bolt construction scheme）.doc

锚杆施工方案（Bolt construction scheme） 1) construction preparation 1. materials (1) the prestressed bar material should be made of steel strand, high strength steel wire or high-strength thread steel bar. When the prestress value is small or the anchor length is less than 20m, the prestressing tendon can also be picked Use grade II or III grade steel bars. (2) cement paste material: cement should be ordinary portland cement, if necessary, can use sulfate resistant cement, not use high alumina cement. Fine aggregate shall be of particle size less than 2mm Medium fine sand. Water shall not be used in accordance with the required water quality. No acid water with a pH value of less than 4 shall be used. (3) plastic sleeve material: should have enough strength to ensure that it is not damaged in the process of processing and installation, with water resistance and chemical stability, and cement mortar and anti-corrosion No adverse reactions were observed. (4) the isolation frame shall be made of steel, plastic or other materials which are not harmful to the rods, and wooden isolation frames shall not be used. (5) anticorrosive material: in the service life of the anchor rod, it should maintain its durability, not cracking or becoming brittle or becoming fluid in the prescribed working temperature or stretching process Adjacent material adverse reaction, should maintain its chemical stability and waterproof, not to bolt free deformation of any restrictions. 2. operating conditions (1) before bolting, the construction equipment, equipment and process should be rationally chosen according to the design requirements, soil conditions and environmental conditions. (2) according to the design requirements and the specifications and models of the machines and equipment, a safe and sufficient construction site shall be laid out. (3) before construction, the quality, type, specifications and quality of each component of the anchor bolt shall be examined carefully, and whether the raw m