悬挑式脚手架（Cantilevered scaffold）.docVIP

悬挑式脚手架（Cantilevered scaffold） Preface Some provisions of Fujian province construction of cantilever scaffold safety technology (Trial) has been implemented in 2004 06 month 01, aiming at the construction of high-rise buildings using the cantilever scaffold, the regulations clearly pointed out that the supporting structure of Overhanging Scaffold shall be made of steel cantilever beam or cantilever truss etc. do not use steel. The overhanging steel scaffolding will be widely used in high-rise buildings. I. Engineering Overview The project is located in Xiamen City, with a floor area of 5819.93m2, a height of 48.9m, a floor number of 15, a jump of 16 floors, a floor area of 10176.28m2, an underground floor, and an upper structure system as a frame structure. The scaffold is made of segmental steel cantilever and cable-stayed steel rope, and is unloaded to the main structure, and the steel is embedded in second and ninth layers. Two, scaffolding erection (1) preparation for construction 1., before setting up, the project leader at all levels must step by step to set up personnel and construction personnel for safety technical disclosure. 2. material approach (1) quality requirements and inspection of steel pipe and fastener; Quality requirements and inspection standards for A steel pipe Geometric dimension of steel pipe Table 1 Steel pipe type, outer diameter, wall thickness, maximum length Welded steel tubes (YB234-63) 48mm, 3.5mm, 6000mm for low pressure fluid delivery Table 2 Check the quality requirements of the project New tube 1 product quality certificate must have 2 steel quality inspection report 3 surface quality surface should be straight, there should be no cracks, delamination, indentation, road and hard bending 4 allowable deviation of outer diameter and wall thickness shall not exceed 0.50mm 5, the end face should be smooth, the end of both ends cutting skew, the deviation shall not be 1.70mm 6 antirust treatment must be antirust: galvanized or painted a