数控车工考证（Research of CNC lathe）.docVIP

数控车工考证（Research of CNC lathe） First, the multiple-choice questions (2 points per game, 20 points) 1, when the vehicle thread, the pitch accuracy can not meet the requirements, and () have nothing to do with it. C A. the axial movement of the lead screw, the B. drive chain clearance, C., the roundness of the spindle neck 2. Normally, the coordinate axis parallel to the spindle of the machine is () B A.X axis, B.Z axis, C.Y axis, D. is not definite 3. The following instruction cannot be used to create a workpiece coordinate system. A A.G98 B.G54 C.G92 D.T0101 4, if the radial amount of turning is much greater than the axial direction, then the cycle instructions should be used. A A.G71 B.G72 C.G73 D.G70 5 which CNC system has the highest machining accuracy?. B A. open-loop servo system CNC machine tools B. closed loop servo system CNC machine tools C. semi closed loop servo system CNC machine tools D. semi open half closed loop servo system CNC machine tools 6, which of the following is not a necessary step in NC machine programming?. C A. analyze part drawings and determine machining parameters B. selects the corresponding interpolation instructions according to the trajectory C. determines the position of the workpiece coordinate system in the machine coordinate system D. calculates the coordinate of the tool path 7, trapezoidal thread rough, fine turning tool () is not the same. C A. only knife edge B., only longitudinal front angle, C. knife sharp angle and longitudinal front angle D. are irrelevant 8, the use of four jaw single action chuck processing eccentric sleeve, if the measured eccentricity, you can (eccentric) the hole axis claw closer. A A. away from B., close to C., symmetrical to D., any one 9. The top holes used for spindle positioning are: () C A. precision benchmark, B. crude benchmark, C. auxiliary benchmark, D. as benchmark 10, FANUC CNC car system G92 instructions for car thread, the following statement is incorrect (). C A. for external thread,