烤漆字制作工艺（Baking paint making process）.docVIP

烤漆字制作工艺（Baking paint making process） Paint word production process Every other paint according to the standard, there are three kinds of call 1:A: B: flat drum drum drum: C tip word word other shape is basically from the three evolution. For example, the tip of the drum can be diamond, round drum can change the evolution of arc, tool selection, cutting just different shades of character modeling are quite different. A: the manufacture and requirements of flat drum words: to be the words of copy paper with the description in the density board, four of the left 5cm, using hand engraving machine with the corresponding straight knife, along the outside of a word mold (internal go in line, the other to go outside). Die out, he cut flat die down. And then use the file and sandpaper the female die each side and the word angle grinding arc shape, must be smooth, uniform, finally using sandpaper. Also available computer engraving machine carved mold, plus enough height after high angular processing can be smooth. B: production and demand sharp drum word: the first step: the method of making the same word with the same drum, but each side of each corner and not grinding arc shape. The second step: heightening, forming. According to the width size, stroke of the word (in the most cost-effective wide, from the second layer is a middle line on both sides of the inclination is 90 degree angle, this angle to locate the heightening thickness, then choose the appropriate 45 degree angle knife is arranged in the multi-function machine, face down a sharp the drum, with 502 glue or glue in three seconds hit parts drop gradually sharp glue to make it hard for some pressing mould damage, no sharp parts of the heightening of the heightening, repair repair place, large font to buy a tool to do only manual repair, forming. C: the manufacture and requirements of drum words: the first step: the method of making the same word with the same drum, but each side of each corner and not grinding ar