结构设计需要控制的几个比值（Several ratios that need to be controlled in structural design）.doc

下载文档 降价啦

2
0
约1.12万字
约 9页
2017-08-18 发布于河南
举报
版权申诉
保障服务

结构设计需要控制的几个比值（Several ratios that need to be controlled in structural design）.doc

1、本文档共9页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

结构设计需要控制的几个比值（Several ratios that need to be controlled in structural design）

结构设计需要控制的几个比值（Several ratios that need to be controlled in structural design） The significance of structure parameter control, method and notice 1 stiffness ratio control A control significance: The new code requires the stiffness ratio between the layers of the structure, and amplifies the seismic force according to the stiffness ratio,. The new standard of structure layer stiffness has clear requirements, in the judgment of whether the floor and basement is weak layer can be used as a fixed end, the conversion layer stiffness meets the requirements and so on, are required to have layer stiffness as the basis, Intuitively, the concept of the layer stiffness ratio is used to represent the overall symmetry of the structure B specification clause: The new seismic code appendix E2.1 provides that the lateral stiffness of the upper and lower layers of the transfer floor of the tubular structure shall not be greater than 2. The 4.4.3 of the new regulation stipulates that the lateral rigidity of the floor structure of seismic design shall not be less than 70% of the lateral stiffness of the upper storey or 80% of the average lateral rigidity of the three storey. The provisions of article 5.3.7, high compliance, calculation of high-rise buildings, the basement roof as the upper structure of fixed end, 2 times of the lateral stiffness of the basement structure should not be less than the lateral stiffness of the structure of the adjacent upper floors. The 10.2.6 section of the new gauge specifies that the large space shear wall structure at the bottom and the lateral stiffness of the upper and lower structures of the transfer storey shall be in accordance with the provisions of the high standard appendix D. E.0.1 is a layer of large space at the bottom part of the frame shear wall structure, can be used to lower the equivalent structure of the conversion layer, the stiffness ratio of gamma said conversion layer changes the upper and lower structural stiffness, non seismic d