装电梯心得（Elevator experience）.docVIP

装电梯心得（Elevator experience） Elevator experience Elevator comfort is good, in addition to good configuration, debugging, and, more importantly, the two rail. Then well consider how to do the rails quickly and well There are several programs can refer to: 1, XY longitudinal direction of each n cm for correcting perpendicularity, coplanarity with rail gauge (old school program), 2 X longitudinal direction of rail surface Mn two lines, at the same time for school verticality and coplanarity (less). 3, X vertical rail surface n distance from the same line for calibration, with a cotton pull coplanar. 4, the support position is placed two lines, with the guide plate and plate gauge. (this is the practice of no scaffolding) 5, the use of advanced instruments, laser rail gauge! Basically, these are the programs. Personally, I think its more accurate and easier to operate without scaffolding! But if you dont have a tool, youd better use the cotton thread! As for rail payment, I personally come up with a relatively easy to operate and more accurate program! Its closed here. Private property applications for patent re sharing. Would Monaike system debugging Whether PLC (microcontroller), WJ (microcomputer), or PC (computer) control system, nothing more than it is a dead program. That is, in the premise of no fault, in accordance with pre-set procedures. Simply speaking, enter an instruction, output an action / input, multiple instructions, output an action. Therefore, Monaike integration system is no exception. The local debugging must comply with the door lock circuit connected, safety circuit connected, all parameters are set correctly. Of course, traveling train must also be sealing the upper and lower limit, forcing deceleration. While debugging must express: slow running normal, normal communication, the floor is set up correctly, all switch limit switch, the installation location is correct and effective, all leveling signal correctly and magnetic isolation plate is inser