带式传动（Belt drive）.docVIP

带式传动（Belt drive） Belt drive.Txt life is over, not want to come out. Put down is once, can not put down is memory. Wherever I am, I only have a turning distance from you. I. transmission scheme Second sets of third data: the design of belt conveyor in the first gear reducer (1) working conditions: the service life is 10 years, each year according to 300 days calculation, two shifts system work, the load is steady. (2) original data: cylinder circumferential force F=1.7KN; belt speed V=1.4m/s; Roller diameter D=220mm. kinematic sketch Two, the choice of motor 1 、 motor type and structure type selection: according to the known working requirements and conditions, choose Y series three-phase asynchronous motor. 2, determine the power of the motor: (1) the total efficiency of the transmission: ETA = ETA with total * ETA 2 * * ETA ETA bearing gear coupling * ETA drum =0.96 x 0.992 x 0.97 x 0.99 * 0.95 =0.86 (2) the work power required by the motor: Pd=FV/1000 is the total =1700 * 1.4/1000 * 0.86 =2.76KW 3, determine the motor speed: Working speed of drum shaft: Nw=60 * 1000V/ PI D =60 * 1000 * 1.4/ pi * 220 =121.5r/min According to [2] reasonable transmission table 2. 2 than the recommended range, V belt transmission ratio Iv=2~4, single gear transmission ratio range of Ic=3~5, then a reasonable transmission ratio range of I to i=6~20, the optional range of the motor speed is nd=i * nw= * 121.5=729~2430r/min (6~20) The synchronous speed that meets this range is 960 r/min and 1420r/min. By 8.1 [table 2], three kinds of motor models are found, as follows Motor type, rated power, motor speed (r/min), transmission ratio of transmission KW same turn, full turn, total transmission ratio, with gear 1 Y132s-6 310009607.93 2.63 2 Y100l2-4 31500142011.683 3.89 Considering the size and weight of motor and transmission, the price and the transmission ratio of belt drive and reducer, the two schemes can be seen as follows: scheme 1, due to the low motor speed, larger transmission devi