扩容磁盘柜到现有的MicrosoftCluster系统资源中.docVIP

?扩容磁盘柜到现有的Microsoft Cluster系统资源中?2008-09-06 13:53:09 分类： 今天遇到一个case，客户原来已经有一套微软集群系统（包括两台服务器和一台磁盘柜），现在又新买一个磁盘柜，他需要把新盘柜加到现有的集群系统中，以满足群集节点对空间的扩容。 微软官方提供一个具体的步骤文档，希望对大家有用： /default.aspx?scid=kb;en-us;175278 ?How to add additional non-hot swap SCSI hard disks to a cluster node on a shared SCSI bus 微View products that this article applies to. Article ID : 175278 Last Review : February 10, 2005 Revision : 4.0 This article was previously published under Q175278 On this page SUMMARY MORE INFORMATION REFERENCES APPLIES TO SUMMARY This article discusses how to add additional non-hot swap small computer system interface (SCSI) hard disks to a cluster node, on a shared SCSI bus. Follow the guidelines discussed in this article if your computer does not support the hot swapping of SCSI hard disks. Back to the top MORE INFORMATION If your computer does not support hot swapping, you must shut down both cluster nodes and turn off the computers to add or replace SCSI disks. You must shut down the cluster nodes completely because the shared SCSI bus is disconnected when you add new disks to the SCSI bus. If the bus is disconnected while you use the cluster, you may lose data or have other drive-related failures. Microsoft recommends that you turn off all the attached hardware while you perform this procedure.?To add additional SCSI hard disks to an existing cluster, use the appropriate method for your version of Microsoft Windows. 1. Change the startup values for the Cluster Disk device (for Windows NT 4.0 Server) or Clusdisk device (for Windows 2000 Server or for Windows Server 2003) and the Cluster service to Disabled. To do so, follow these steps: a. For Windows NT 4.0 Server: 1. Click?Start, point to?Settings, and then click?Control Panel. 2. Double-click?Devices. 3. In the list of devices, click?Cluster Disk, and then click?Startup. 4. Click?Disabled, click?OK, and then click?Close. 5. Close the?Devices?window. 6. In Control Panel, double-click?Services. 7. In the l