打印机恢复设置（Printer restore settings）.doc

打印机恢复设置（Printer restore settings） 1. turn off the power. 2. press and hold the STATION2 key on the operation panel, then turn on the power. 3. press and hold the STATION2 key on the operation panel until the printers mechanical action stops. 4. insert a paper of at least A4 size (210mm * 297mm) into the middle of the feeder slot. At this point, the printer will automatically align the paper and send it to the correct print position. The two page test configuration table will be printed and the printer can be stopped to stop the test operation. HCC PR2 advanced passbook printer maintenance manual basic operation L print self check (each printer must be repaired) 1. turn off the power 2. press and hold the Station2 button on the operating panel, then turn on the power until the printer initialization action is completed 3. insert a A4 sized paper into the middle of the feed slot, when the printer automatically aligns the paper and goes to the correct print position 4. then cycle back and print out a test configuration table L parameter settings 1. turn off the power 2. hold the Station1 and Station2 keys on the operating panel at the same time, then turn on the power until the printer initialization action is completed 3. insert a A4 specification paper into the paper tray 4. the printer starts drawing paper and prints two lines of prompt information 5. press the Local button once, and the printer goes into settings 6. if you press the Station1 key, you recognize and save the parameter; if you press the Station2 key, change the parameter until the parameter you want to change or set is complete 7. parameter change is completed, press the Local key, then press the Station1 button once heard the printer send out two clear call after shutdown. (this parameter change good saved) L monitoring program refresh Connect the printer to the COM1 port of the host; Open the top cover of the printer, hold down the [STATION1] and [LOCAL] keys, start the machine and cover the top cov