模钳1（Die clamp 1）.doc

模钳1（Die clamp 1） 1. in the part assembly process, the final naturally formed size is called (assembly dimension chain) 2. thermal expansion in physical fixation is the use of material (thermal expansion, contraction) characteristics of fastening 3. in the mold assembly, the assembly accuracy is not entirely dependent on the assembly accuracy of parts assembly method is called (incomplete exchange method) 4. chemical fixation method according to the adhesive has (epoxy resin bonding method) and (inorganic resin bonding method) and (anaerobic adhesive bonding method) and so on 5., with the guide die assembly, can be used to assemble the standard parts of the guide plate (convex touch) and (concave touch), as well as convex and concave mold In the 6. compound die, the concave convex die not only plays the role of blanking punch, but also plays the role of punching die 7. stamping die in the press should be installed on the first (touch) part, then install (touch) part 8. test mold, the mold installed in the equipment should be carried out (no-load operation) to ensure that all moving parts are normal 9. mold installation by the mould lifting, small and medium sized mold should be used (overall) lifting 10. the main contents of the die inspection are around the quality defects of the parts to check the problems on the mold 11., in actual production, the viscosity (viscosity) is often used as the main sign of lubricant selection 12. after the die assembly, in order to ensure the clamping force, after assembly, the locking block and the slide block slope contact, leaving the gap between the parting surfaces (0.2mm) for repair 13. the working parts of the die are damaged and there are two kinds of wear and tear 14. small punch in the use of damage easily occur (broken) and (bending) 15. the cooling methods commonly used in die casting die are air cooling and water cooling 16. after mold maintenance, must be carried out (debugging) and (test), until the qualified parts can