复合弓校准（Compound bow alignment）.docVIP

复合弓校准（Compound bow alignment） I. coarse adjustment: The coarse adjustment procedure is as follows: the equipment state inspection, adjustment, adjustable distance: reducing the pounds of force, aperture position adjustment, arrow height adjustment, arrow point adjustment. (1) state inspection equipment: the main contents of inspection equipment are in good condition, the main fixing piece is solid, the bow piece has no crack, sight, arrow, balance rod, ball mushroom accessories is installed in place, firmly. This step seems simple, actually is very important, as an important part of bow piece etc. there are cracks or loose fasteners may cause serious consequences; loose parts may make the subsequent adjustment process failed. (2) adjust pounds: adjust the size of bow pull. The number of pounds adjustment is mainly realized by rotating the bow piece fixed seat gravity adjustment screw, general composite bow factory are located in the calibration of the number of pounds pounds highest value, the user can according to their own strength, the number of pounds in equipment can choose a few pounds you need adjusting range, beginners should not blindly pursue the high number of pounds, and should be based on their use of relatively easy, can continuous emission more arrows and not apparent fatigue as the standard, so as to concentrate on the formation of the correct action. In general, the clockwise direction is tightened, the number of pounds increase, the counterclockwise direction is loosened, the number of pounds reduced. Must pay attention to two points, the gravity screw bow piece must twist the same direction, the same number of turns, can not remember the scope of adjustment, each brand has its bow weight adjustment range, such as 50~60 pounds, and the number of ring relaxation of gravity screws are limited, this may cause the screw tripping and have serious consequences for you and your equipment. (3) adjust the distance and force reduction value: distance adjustm