导线算法（Traverse algorithm）.doc

导线算法（Traverse algorithm） Load current is estimated first 1. uses This is based on the power of electrical equipment (kW or kVA) to calculate the current (ANN) formula. The size of the current is directly related to power, voltage, and also dont rate (also known as power factor and so on). Formulas are generally available for calculation. Because the factory is usually 380/220 volt three-phase four wire system, so you can directly calculate the current according to the size of the power. 2. formula Low voltage 380/220 volt system, current per kilowatt, ann. KW, current, how to calculate? Power doubling, electric plus half. 1. Single-phase kilowatt, 4.5 ann. 2 Single phase 380, current two a.. 3 3. instructions The formula is 380/220 volts three-phase equipment in three-phase four wire systems prevail, calculated on the number of kilowatt hour. For some single or different voltage single-phase equipment, the per kilowatt security number, also explains the formula. The two formulas, the power to the motor. At 380 volts three-phase (rate 0.8), the current per kW motor is about 2 kW. An imminent number doubled (by 2) is the current. This current is also called the rated current of an electric motor. [case 1] 5.5 kW motor by double power, the current is 11. [case 2] 40 kW water pump motor is doubled by electric power, and the current is 80. Electric heating is a resistance furnace, such as a resistor. A three-phase 380 volt electric heating device with a current of 1.5 kilowatts per kilowatt. About half of the kilowatt count (by 1.5) is current, ann. [case 1] 3 kilowatts of electric heaters press electric plus half, and the current is 4.5. [case 2] 15 kW resistance furnace according to electric plus half, the current is 23. This sentence does not specifically refer to formula is also suitable for heating, lighting. Although the lighting bulb is single-phase instead of three-phase, the three-phase four wire trunk for lighting is still three-phase. This can be calculated as