NDTProcedure无损检测程序.docVIP

D C B A 16-7-16 CFC Liangliang HU Jian Sun Hongqian Chu REV. Date Status Drafted by Reviewed by Approved by Modification The supply of Turkey KARABIGA 2×660MW USC coal Fired Power Plant project （PURCHASE ORDER：4101185344/0 ） NDT Procedure Issued by SHANDONG SUNHE POWER TECHNOLOGY Co., Ltd. Internal identification number 内部编码 It must not be used, reproduced, transmitted or disclosed without the prior written permission of the Shandong SUNHE POWER TECHNOLOGY Co., Ltd. 本文件,未经山东尚核电力科技有限公司书面批准不得外用、复制和泄露。 一、The delegate of NDT无损检测的委托 Need to be detected according to the drawings or technical documents, materials, parts or products, must after appearance quality inspection, nondestructive testing orders will be completed by the clients, after the client inspectors signature confirmation, I conduct nondestructive testing department test. Orders of NDT testing on the basis of nondestructive testing personnel, is my company commissioned, after carefully review orders, once found the problem, should be timely feedback to the entrusted departments or personnel. Review highlights include checking the product number, name, were, detection methods, detection ratio, entrusted by the qualified level is conformed to the drawings, standards and specification requirements. 根据图样或技术文件要求，需检测的材料、零部件或产品，必须经外观质量检查合格后，由委托方填写无损检测委托单，经委托方检查人员签章确认后，交我公司无损检测部门实施检测。 无损检测委托单是我公司无损检测人员检测的依据，接受委托后，要认真审查委托单，一旦发现问题，应及时向委托部门或人员反馈信息。审查重点包括核对产品编号、名称、台次、委托的检测方法、检测比例、合格级别等是否符合图样、标准及规范要求。 二、The prepare of NDT无损检测的准备 Should be fully prepared before implementation of nondestructive testing. Mainly has the following three aspects: 1, nondestructive testing personnel According to the requirement of the nondestructive testing orders, arrange testing has the corresponding qualification of NDT personnel. 2, instruments and equipment calibration Nondestructive testing instruments and equipment shall meet the requirements of the product