班组操作规程（Operation rules of teams and groups）.docVIP

班组操作规程（Operation rules of teams and groups） Rules for operation of shear panels 1. 、 familiar with the operation performance of cutting machine, the equipment is in good condition, the products produced should meet the technical requirements of our factory. According to the blanking drawing size, raw materials and reasonable collocation, can use small material, resolutely not material saving in aniseed, the principle of reasonable materials. Waste materials are not to be wasted. 2, strictly according to drawing size, processing. All kinds of workpieces must be cut with four sides. At the same time, there must be no burrs, burrs, and the workpiece must not be bent. Workpiece, the maximum error shall not exceed eleven 0.3MM, diagonal error shall not exceed 0.5MM. When the cutting edge is blunt and the workpiece is burr, we should report to the person in charge in time and deal with the problem. 3, the number and time of workpiece processing must be processed according to the production order issued by the factory, no more processing or less processing. A batch of workpieces must be sized and finished at one time and shall not be towed to the next batch. Must be completed on time, quality and quantity, shall not delay the next process work. 4, all semi-finished work should be handled with care, put in order, must not mess, still can not be bruised. All work areas must be cleaned before work. 5, bruised or bruised iron plate, shall not be used for doors, side, and other important components of the front face, if badly bruised, should be handled flat, rear can be used. 6, to achieve the first workpiece inspection. The dimensions are accurate and consistent with the drawings. And the technical requirements are satisfied, we can mass production. The team leader is responsible for the work 7, this group of staff must obey the team leader unified arrangement, strictly abide by the operating procedures, serious operation. Make due contribution to the improvement of product qu