组装（Assemble）.docVIP

组装（Assemble） Preparation before assembly 1) prepare a spacious workbench, preferably a dedicated computer desk. (2) check whether the mains power supply has the three wire outlet of the earth wire. Ready to imitate the electrostatic bracelet, or other ways to release the body with static electricity. (3) prepare a special plug for the chevron plug. (4) read the instructions of each component carefully, especially the matters needing attention, configuration methods, installation methods, installation requirements of accompanying software, etc.. (5) prepare a DOS system startup floppy disk, a set of operating system installation disk, card driver disk and common tool software. (6) disconnect all the power plug and socket from the mains. In any case, parts in a live plug-in unit are not allowed. (7) on the motherboard for jumper, installation of CPU and memory, it is best to solder on the motherboard surface of an anti-static sponge (usually in the motherboard package with such a sponge) (8) prepare screwdrivers and pliers, and multimeter, long tweezers, flashlight and anti-static gloves etc.. Operating procedures and instructions 1) install the power supply. Put the power on the power rack on the back of the case, and fix the screw hole on the power source to the fixed hole on the case. First twist the two screws on the diagonal position, secure the power, then screw the remaining two screws to the right position. 2) install CPU. When you install the CPU should be gently CPU socket beside the ZIF pull rod, left lug design rod stuck in the CPU side of the socket, the pull rod pull to the motherboard and the vertical position, at this time should first determine the CPU pin of the missing angle direction, then the CPU pin alignment pinhole socket and insert CPU Jack slowly, a little under CPU. 3) install the CPU radiator. With a soft towel to wipe clean CPU metal cover plate, and then the thermal grease on the surface of CPU uniformly coated with a layer, and then remo