fanuc系统部分功能的技术术语及解释（Technical terms and explanations of some functions of FANUC system）.docVIP

fanuc系统部分功能的技术术语及解释（Technical terms and explanations of some functions of FANUC system） Technical terms and explanations of some functions of FANUC system: 1, control trajectory number (Controlled, Path) CNC controls the number of feed servo shafts (feed). Each tool forms a tool path during machining. Each group can exercise separately and coordinate the movements at the same time. 2, control axle number (Controlled) CNC controls the total number of feed servos / each locus. 3, linkage control axis number (Simultaneously, Controlled, Axes) The number of feed servo axes that are interpolated at the same time per locus. 4, PMC control shaft (Axis, control, by, PMC) Feed servo shaft controlled by PMC (programmable machine tool controller). The control command is programmed in the PMC program (ladder diagram), so it is inconvenient to modify. So, this method is usually used only for fixed feed axis control. 5, Cf axis control (Cf, Axis, Control) In lathe system, the rotating position (corner) of spindle is controlled by other feed shaft, which is realized by feed servo motor. The shaft is linked with other feed shafts to interpolate and process arbitrary curves. 6, Cs contour control (Cf contouring control) (T Series) In lathe system, the rotation (position) of spindle is controlled by FANUC spindle motor instead of feed servo motor. The position (angle) of the spindle is detected by a high resolution encoder mounted on the spindle (not the spindle motor). At this point, the main shaft is used as the feed servo shaft, the movement speed is: degree / minute. It can be interpolated simultaneously with other feed shafts, and the contour curve is processed. 7, Control Axis (Rotary) The feed shaft is set as a rotary shaft for angle position control. The angle of gyration is set to any parameter. The FANUC system is usually just a feed shaft other than the basic axis and can be turned into a rotating shaft. 8. Control shaft is disengaged (Controlled, Axis, Detach) Specifies t