二级建造师法规习题集（Two stage builder code set）.docVIP

二级建造师法规习题集（Two stage builder code set） The __________ minimum value allowed. The top 21. vertical curve in convex or concave vertical curve should be avoided at the bottom of the insert _________ curve, or the vertex as reverse curve ______________. The final results of 22. longitudinal section design, mainly reflected in the line of _________ and _____________. The longitudinal slope of 23. transition slope segments of not more than _________, and slope length shall not __________ minimum slope length value. The average slope is 24. two or three, four highway crossing route, generally close to _________ (relative elevation 200-500m) and _________ (relative elevation of more than 500m) is appropriate, and note any average longitudinal slope is greater than ___________ connected section 3km. 25. highway and the highway, when the slope is greater than ___________, a climbing lane, its width is generally _______________. 26. levels of highway __________ Road, and other sections of ___________, should use the longitudinal slope of not less than 0.3%. Two, multiple-choice questions 1. elevation of subgrade design generally refers to (). A. subgrade centerline elevation; B. pavement edge C. elevation; shoulder edge elevation; embankment slope elevation D. 2. highway with intermediate belt and first class highway whose design elevation is (). A. pavement centerline elevation; B. pavement edge elevation; C. elevation of the outer edge of the curb belt; elevation of the outer edge of the D. central divider The minimum length and minimum radius of 3. convex vertical curves are determined mainly according to (). A. travel time, centrifugal acceleration and sight distance; B. travel time and centrifugal force; C. travel time and sight distance; D. sight distance and centrifugal acceleration 4. the difference in the number of miles corresponding to the end of the vertical curve is the vertical curve. A. tangent length; B. tangent difference; C. curve length 5. the limiting value