外墙保温技术交底（External wall insulation technical disclosure）.doc

外墙保温技术交底（External wall insulation technical disclosure） Can take the method of directly using anchor fixed, fixed quantity should be considered the height of the building and the nature of the wall. The 2. bomb line In accordance with the provisions of the drawings play water level in the design of expansion joints at the telescopic seam width pop-up wall line etc.. Set in the vertical angle of yin and Yang in the two wall, pop-up vertical line, the line insulation board construction verticality inspection. 3. modulation of polyphenyl granule The water bucket clean pour about 5.5kg, adding amount of powder polystyrene particles, and with a low speed agitator into slurry consistency is moderate, the net for 5 minutes. Before use, stir it once again. A good tune should be used within 2 hours of mortar. 4. laying over packet networks Combined cutting over packet mesh width is 200mm+ the thickness of the insulation board. First in the base wall all doors and windows, surrounding the hole and terminal system, apply adhesive powder polystyrene particles, width 100mm, thickness of 2mm. The mesh side 100mm clipping good press glue, a mesh exposed is not allowed, the polyphenyl granule edge redundant scrape, keep out of cloth cleaning part. 5. insulation board 5.1. insulation board for extruded sheet should be brushing glue side brushing a dedicated interface agent, placed 20 minutes to dry after use. 5.2. insulation board should generally adopt the transverse paving the way from bottom to top laying, staggered joint width of 1/2 plate length, appropriate cutting when necessary, size deviation not more than 1.5mm. 5.3. insulation board is coated with a layer of adhesive evenly around powder polystyrene particles, with width 50mm, thickness 10mm, and on one side of the plate for 50mm wide exhaust hole, middle part of the stick, diameter 100mm, thickness 10mm, pitch 200mm, 1200mm * 600mm for the standard plate, the middle with 8 points and for non standard board, insulation bo