2010真题复习参考（2010 exam review）.docVIP

2010真题复习参考（2010 exam review） National two construction division qualification examination, construction engineering management and practice simulation test questions First, individual choice questions (20 questions, 1 points each). Each item options, only 1 of the most to do) 1.. Material. Section size. Rod height and load point are the same, the maximum critical load is () A, ends hinged B, one end articulated, fixed at one end C, both ends fixed D, both ends free 2. in the interior decoration of house building, the bonsai added on the ground belongs to (). A. concentrated load B. uniformly distributed load C. line load; D. surface load 3. a section is 370*490 mm brick column, the column calculation height is 5.5 m, its height thickness ratio is () A, 11.22, B, 0.01 C, 14.87, D, 0.15 4. a cast-in-place concrete structure, the strength level of concrete is C30, in which the span of 6m beam and cantilever length of 1.2m balcony plate of the bottom mold, should be the strength of concrete reached (), can be removed. A.21N/mm2, 22.5N/mm2, B., 30N/mm2, 21N/mm2 C., 22.5N/mm2, 30N/mm2, D.30N/mm2, 30N/mm2 5., mass concrete construction should not adopt (). A, volcanic ash Portland cement, B and fly ash Portland cement C, ordinary portland cement, D and slag Portland cement 6, in the excavation of the foundation pit (groove), the incorrect statement is (). A. when the slope is steep, the foundation pit is deep and the geological condition is bad, reinforcement measures should be taken Generally, B. should adopt the principle of layered excavation, first excavation and back support C. shall take measures to prevent the disturbance of foundation soil D. soil below the water table should be excavated after precipitation 7, a cross-section of reinforced concrete beams, section size of 200*500mm, with 3 Phi 20 of grade I steel, concrete protective layer thickness of 25 mm, gravel size should be (mm). A.2 - 20 B.5 - 25 C.5 - 31.5 D.5 - 40 8, artificial marble is () artificial sto